07 Февраля 2025 | пятница | 05:35
Energoterra

"Turboatom" has manufactured and shipped hydraulic turbine shaft for Dnepro HPP-II (Ukraine)

Мая 20, 2014

The specialists of OJSC "Turboatom" has manufactured and tested hydroturbine shaft for Dnepro HPP-II (station No. 18). In April 2014, turbine shaft with parts and guide vane servomotors were shipped to the station.

Under the contract, signed in 2011 OJSC "Turboatom" modernizes three propeller-type turbines No.No.11, 17, 18 replacing for Kaplan hydraulic units at Dnepro HPP-II. After modernizing the unit capacity of turbines is expected to increase from 115 MW to 122 MW, average efficiency reaches 93.5% and the runner diameter is expected to increase from 6,8 to 7 m.

"Turboatom" performs "turnkey" contract, the scope of obligations of the enterprise includes design, manufacture, supply of equipment and installation, pre-commissioning and put into operation turbines.

The range of equipment includes embedded parts, runners, guide vanes, shafts, turbine mechanisms and regulating systems.

Start-up of the hydraulic unit No. 18 is scheduled for January 2015, the turbine No. 17 is planned to start in October 2015.

In 2013 after modernizing the hydraulic unit No.11 was put into operation.

См. также:
Энергобезопасность и энергосбережение в ЖКХ
Правило Legrand: современный офис – это эффективное освещение каждого квадратного метра
 

Контакты
Адрес: 115114 Россия,
620137 г. Екатеринбург, ул. Студенческая, д. 1 корп. 3
Тел. / факс  (343) 345-09-72
г. Москва, 1-й Дербеневский переулок, д. 5 тел. (495) 287-98-51
E-mail: info@energyland.info
О проекте Powered by <Unknown> engine